Perbandingan Nilai Kekuatan Tarik Komposit Menggunakan Metode Hand Lay Up Dan Metode Vari
Abstract
Some Types of the method of making composite materials are the Vacuum Assited Resin Infusion (VARI) Method and the Hand Lay Up Method. The purpose of this study was to compare the tensile strength of composite materials made using the hand lay up and VARI methods. The types of fibers used as composite materials are palm frond fibers and matrices used in polyester resin. Composites reinforced with palm fronds are printed using the hand lay up and VARI methods. The results showed the value of composite tensile strength with the hand lay up method of 27.37 MPa and composite tensile strength using the VARI method of 28.40 MPa. From the results of the study, the differences in the tensile strength values of the two methods were obtained.
Downloads
References
Callister. 2010. Material Science And Engineering : An Introduction. New York: John Wiley & Sons, Inc
Febrianto, S, 2011. Penggunaan Metode Vacuum Assisted Resin Infusion Pada Bahan Uji Komposit Sandwich Untuk Aplikasi Kapal Bersayap Wise-8 Depok Universitas Indonesia.
Prayoga, Aditya, 2013.Pembuatan Propeler Blade Komposit Ijuk – Resin Untuk Turbin Mikro Hidro Kapasitas 550W dengan Teknik Vacuum Asisted Resin Infusion. Skripsi, Teknik Mesin Universitas Pasundan.
Refiadi Gunawan, 2005.Pembuatan Material Komposit dengan Metode Vacuum Asisted Resin Infusion. Berita Teknologi dan Barang Teknik No 19/2005.
Copyright (c) 2019 Lega Putri Utami, Delovita Ginting
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Each article is copyrighted © by its author(s) and is published under license from the author(s).
When a paper is accepted for publication, authors will be requested to agree with the Creative Commons Attribution-Noncommercial-No Derivative Works 4.0
Abstract views: 973 , 
PDF downloads: 1086
